anycubic S does not transport filament

How to make filament for 3d printer? Forums Community Forum anycubic S does not transport filament

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #1298
    dreezy
    Participant

    I had made some filament out of a bottle, but my anycubic S does not transport the new filament.
    The nozzle i use to made filament is around 1,6 mm, my idea is that the transport unit is slipping over the filament. Is there anything that can be done about it? I don’t want to convert my entire 3d printer for that.

    To load the filament, i had to push it into the transporter to get it by the nozzle.

    • This topic was modified 2 months, 2 weeks ago by dreezy.
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.